You only have to match your device if you've received the Wireless Kill Switch (WKS) as an add-on accessory or you're replacing a lost or damaged device. If the remote came as a system kit, it will already be matched with your receiver.

You can match your WKS with your receiver in two ways:

• Using the built-in magnets on the back of the device.
• Power cycling the receiver. For example, turning the vehicle ignition on and off.

Match your remote and receiver using built-in magnets

There are two built-in magnets on the back of the WKS and a sensor under the Aarcomm logo on the receiver.

To match your device with a receiver, both units must be in match mode. Once the receiver is in match mode, you have 60 seconds to match the device with the receiver.

1. Start with both the receiver and WKS off.
2. Turn the receiver on. The LED should be white.
3. Wave the magnets on your device over the sensor on the receiver until the LED light changes to dark blue. This indicates that the receiver is in match mode.
4. Press and hold the red button. The red LED will turn on.
5. With the red button pressed, press and hold the top-left and bottom-left buttons. The green LED will turn on.
   

   

6. With both lights on, release the red button and the top-left and bottom-left buttons. The screen will say Match Mode, followed by Match Passed.
7. Turn on both the remote. Your system is ready to operate.

Match your remote and receiver using the power switch

Use this method if you can't physically access the receiver. After putting the remote into match mode, you have 60 seconds to put the receiver in match mode. Since you may not be able to see the receiver's LED, put the WKS into match mode first:

1. Turn off the WKS.
2. Press and hold the red button. The red LED will turn on.
3. Press and hold the top-left and bottom-left buttons. The green LED will turn on.
   

   

4. With both lights on, release the red button and the bottom two buttons on the left side.
5. Turn the power of the receiver on for one second then off for a half second.
6. Repeat six to seven times. On the final switch, keep the power on.
7. Check the screen of your remote device for the Match Successful message. Your system is ready to operate.

Match failed

If you get a Match Failed message, it could mean:

• The receiver wasn't powered on or didn't enter match mode and the remote device timed out
• There's incompatible software on the remote device and receiver. Contact our support team for further assistance.